Run the engine with the radiator cap off. Reinstall the thermostat, removing the housing so you can connect the thermostat to the engine, and then reinstall the housing with its bolts.įill the radiator with a fresh 50/50 mix of water and antifreeze-fill it slowly until the coolant reaches the base of the filler neck, then fill the reservoir to the "cold fill" mark. Reconnect the upper radiator hose using its clamp. Let the water run until it comes out completely clear, then turn off the water and remove the hose from the radiator inlet. Turn on the hose and look for the water to come out of the disconnected radiator hose. Insert a garden hose into the inlet the hose was connected to. Remove the thermostat from the engine, then reconnect the thermostat housing without the thermostat.ĭisconnect the upper radiator hose: Loosen its hose clamp with pliers. Unbolt and remove the thermostat housing from the engine using a wrench-tap the housing with a small rubber mallet if it is stuck. If the Liberty has a V6 engine, drain the remaining coolant from a second drain fitting at the engine block. How to Flush the Radiator on a Jeep Libertyĭrain the engine coolant: Place a large container under the radiator drain fitting and open the fitting so the coolant will drain out. If not, screw the radiator cap securely back into position and close the hood. Then, shut off the engine and check the coolant level. Allow the Toyota Camry to run until the cooling fan turns on twice. Start the engine and turn the heater to the high setting. Refill the radiator until it's within an inch of overflowing. In the Toyota Camry, you want to use Toyota Super Long Life Pink premixed coolant. Make sure to close the drain plug again and refill the radiator with fresh coolant. Repeat this process until there isn't any debris in the flush. The flushing requires about 3 gallons of distilled water. Then, open the drain plug to let the water flow into the bucket. Once done, pour the old coolant into a sealable container for proper disposal later.Ĭlose the drain plug and fill the radiator completely with distilled water. You may need a socket wrench to loosen the drain plug. Open the drain plug and allow the coolant to drain completely from the radiator. The drain plug on a Toyota Camry is usually on the back passenger side of the radiator. Place a bucket with a minimum 2-gallon capacity, underneath the radiator and below the drain plug. The one full twist of the radiator helps relieve that pressure. You want to pause because even though the radiator is cool, there can still be internal pressure. Twist the radiator cap one full turn, pause for a few seconds, and then completely remove the radiator cap.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |